Produces a quick drying, natural satin / matt water repellent, tread-fast finish that will not peel or flake. Easy application, no sanding between coats.

To maintain / renovate, simply wash, buff or re-apply, following the guidelines below:

• Suitable for application onto children's toys – EN 71-Toy Safety Test
• Resistant to liquids: Tested in accordance with BS 3900 G5
• Resistant to wear: Tested in accordance with BS3900 E15

• Ensure all surfaces are clean, dry, and free from any previous finish.
• Sand the substrate with a fine 150 grade sanding paper or 150 grit sanding disk, removing all traces of dust.

Application

• Ensure all areas to be coated are extremely well ventilated during and after application.
• Always test on a small area prior to initial application.
• No primer required.
• Maximum 2 coats recommended.
• Apply at room temperature.
• Fiddes Hard Wax Oil is formulated for application directly, and does not require thinning.

First Coat –

• Stir contents thoroughly before and during use, and apply in a warm, well ventilated room.
• Apply THINLY using a good quality bristle or synthetic brush like OSMO Floor brush and lay EVENLEY, following the direction of the grain.
• Remove any surplus material immediately with a cloth, carefully checking all areas for any excess application.
• Leave to dry 4-6 hours in warm, dry well ventilated conditions, or preferably overnight.

Second Coat –

• Apply as first coat, THINLY, allowing good ventilation.
• Leave to dry 4-6 hours in warm, dry well ventilated conditions, or preferably overnight.
• When the surface area is completely dry, a light buff will further enhance the sheen level.

• Ensure all areas to be coated are extremely well ventilated during and after application has occurred.
• Always test on a small area prior to major application.
• Certain dense or oily substrates may only require a single application, and subsequently buffed to achieve the desired finish.
• Longer drying periods may occur during application in cold, damp or humid conditions.
• Always apply sparingly and remove any excess product thoroughly.
• Re-Application: To renovate previous application of Fiddes Hard Wax Oil, lightly sand area with 150 grit sandpaper, and re-apply sparingly.

Material Safety Data Sheet