|
Product |
Pricing |
|
2-Part Water Based Clear Epoxy Primer/Sealer Gallon kit |
$80.00 |
2-Part Water Based Clear Epoxy Primer/Sealer 5 Gallon kit |
$399.95 |
Eco-Tuff 2-Part Water Based Clear Epoxy Primer/Sealer:
Approximate Spread Rate:
250-300 sq.ft./gal. A one coat application product.
Features:
-
Green Building Compliant
-
Excellent Durability
-
Excellent Bonding
-
No HAP's or TAP's
-
Low VOC
-
Very Low Odor
-
Non-Flammable
-
Water Proof
-
Abrasion Resistant
-
Chemical Resistant
TECHNICAL DATA:
Installation Temperature: Above 40º F (4º C) to 120º F (49º C)
Relative Humidity: 85% maximum, below 80% for best results
Approx. Coverage: 200-250 sq.ft/gal (60.96-76.20 sq. meter)
Dry to Touch: 1 Hour Volume
Serviceability to Topcoat: Minimum 6 hours @ 72º F (22º C) Maximum 48 hours @ 72º F (22º C)
Finish: Matte - Color: Clear
VOC Content: <120 g/l, 1.0 lb/gal
Odor: Low, Slightly Sweet
Volume Solids: 38%
Net Weight: 9 lbs/gal (4.1 kg)
Pot Life: 90 Minutes @ 72º F (22º C)
APPLICATION:
Patch all imperfections, cracks, etc. with concrete patch filler and flexible joint fillers. DO NOT USE SILICONE PRODUCTS. Surfaces must be clean, dry, sound, and free of oils, waxes, grease, rust, loose material, etc. Good surface porosity will ensure the most durable system. Sand, grind or chemically etch (
Eco-Etch) non-porous surfaces prior to application. Previously painted surfaces must be sound; otherwise the coating may lift along with the undercoat. Mixing ratio 1:1 parts epoxy resin/hardener by volume. Thinning is not recommended. To mix 1 gallon units, use an electric or air mixer (approximately 250-500 rpm) with a metal mixing blade (Jiffy Model HS or equal). Pour Hardener (Part B) contents into slack-filled Resin Can (Part A) and mix for 2 to 3 minutes until material is thoroughly blended and emulsified. To mix 5 gallon units, use the same procedure as the 1 gallon unit except use a larger mixing blade. Working out of the paint can or bucket with grid, apply material to the surface using a 3/8” nap roller cover. Product can be top coated in 6 hours @ 72º F (22º C) MIX ONLY EQUAL AMOUNTS NEEDED IF USING LESS THAN FULL KIT QUANTITY. STIR CONTAINER THOROUGHLY BEFORE AND DURING APPLICATION. USE WITHIN POT LIFE LIMITATION.
